Production

Production

The working process starts with the cleaning of the moulds, continues with their wax-coating, and ends by their painting with a first layer of gelcoat in the colour chosen by the customer.
In the moulding room both the hull and the deck are produced (with a “sandwich” technique), assembled and then pulled out from the moulds. In the meantime the tubes go through the whole assembly and graphic set-up, while other components such as the console, the roll bar, and the platforms are brought in.
Once all these accessories are ready, the production continues in the assembly room, where the tubes are assembled and decorated according to the models and colours requested by the customers. While preparing the tubes, also the structural components such as the console are set up.
At the end of the manufacturing process, we move to the finishing room, where the different accessories, such as winches, cleats, steering wheel, handrails (produced in our steel plant), and lastly cushions, are assembled.
As a last step, the boat is cleaned, the basic systems (electric system, ventilation and fuel) double-checked, and finally the boat is wrapped in a polyethylene heat-shrink film , ready to be transported to its destination.

The various phases of the production process
  • pulling out from the moulds
  • hull assembly
  • tubes cleaning
  • mounting accessories
  • mounting accessories
  • equipment trials
  • installing the registration number plate
  • cushions assembly
  • final cleaning
  • testing sheets and curtains
  • final cleaning